The Zone Monitor powers and controls a zone of up to 20 Series 65 conventional fire detectors from a loop of DEMCO’s addressable detectors and interfaces.
The Zone Monitor is loop powered and operates at 17–28V DC with protocol pulses of 5–9V. It is supplied with a backbox for surface mounting, and is also available without the backbox for flush mounting. Both versions are for indoor use only. Two LEDs, one red and one yellow, are visible through the front of the enclosure. The red LED indicates that a fire condition has been detected on the zone wiring. The yellow LED is lit when the built-in isolator has sensed a short circuit loop fault.
|Zone Voltage (loop voltage ?22V)||19V±1V|
|Zone voltage (loop voltage <22V||Loop voltage -1.5V|
|Switch-on surge, max 150ms||3.5mA|
|Quiescent||4mA + detector load|
|Operating Temperature||–20°C to +70°C|
|Humidity (no condensation)||0–95% RH|
|Dimensions of Zone Monitor Unit (surface mount)||150 x 90 x 48 mm|
Feel free to ask any questions over the phone, or get in touch via our contact form below. Your message will be dispatched directly to our staff who will answer as soon as they can.