Quantec Controller (Model QT601-2)
QUANTEC CONTROLLER
(MODEL QT601-2)
The Quantec Controller supplies power to and controls a Quantec Addressable Call System. This monitors all network devices and manages the routing and distribution of all calls.
The Quantec Controller provides connections for network wiring, standby batteries, a laptop (for system programming), optional paging/DECT equipment, an optional printer or PC (to run Quantec’s QT707S Surveyor data management software). It can be semi-flush mounted using an QT385 bezel or fully-flushed using a BF359/3S stainless steel enclosure.
- Supplies power to and controls a Quantec Addressable Call System.
- Monitors all network devices and manages the routing and distribution of all calls.
- Provides connections for network wiring, standby batteries, a laptop (for system programming),optional paging/DECT equipment, an optional printer or PC (to run Quantec’s QT707S Surveyor data management software).
- Includes a library of 40 pre-set & 45 custom place names.
- System setup requires a laptop PC running Quantec’s QT707 programming tools.
- Can be semi-flush mounted using an QT385 bezel or fully-flushed using a BF359/3S stainless steel enclosure.
- System wiring requires one or more QT603 network splitters.
- Wiring should be made in a spine and limb arrangement using 1.5 to 2.5mm2 T&E (spines) and 4 to 8 core stranded security cable (limbs).
| Mains supply | 230V 50/60Hz. |
| Mains rated current |
350mA maximum.
|
| Internal power supply | 27Vdc nominal. |
| Total output current limited to | 3A @ 230Vac. |
| Quiescent current | 100mA @ 24V |
| Max battery size and type |
2 x 12V 7Ah VRLA connected in series.
|
| Cabling |
Spine & limb arrangement using QT603 network splitters. Spines wired in 1.5-2.5mm2 T&E; Limbs wired in 4 core stranded security cable (up to 6 limbs per QT603 splitter). Refer to main instructions for more details.
|
| Open collector outputs |
OP1 (active on standard call); OP2 (active on help req. call); OP3 (active on emergency call); OP4 (active on attack call). OP5 (failsafe fault output). Voltfree single pole c/o. Max. switch current 25mA; Max. switch voltage 30Vdc.
|
| Other outputs |
24V Aux. Power (19.5V min, 28V max). Protected by a resettable fuse. Max. current 100mA.
|